Drilling Cycles And - Siemens SINUMERIK 840D Programming Manual

1
General
1.5 Cycle support in program editor (SW 5.1 and higher)
Example
The following DIN code is
created from the following input
screen form for a 2-straight-line
contour definition creates the
following DIN code:
X=AC(20) ANG=87.3 RND=2.5 F2000 S500 M3
X=IC(10) Y=IC(-20); end point incremental
Drilling support
The drilling support includes a selection of drilling
cycles and drilling patterns.
Drilling
centering
Deep hole
drilling
Bore
Tapping
Selection of drilling patterns
Hole pat-
tern pos.
Deselect
modal
Cycles CYCLE81, CYCLE87 and CYCLE89 cannot be
parameterized with this support.
The function of CYCLE81 is covered by CYCLE82 (soft
key "Drilling center."), as is the function of CYCLE89.
The function of CYCLE87 is covered by the function of
CYCLE88 (soft keys "Drilling center." à "Drilling with
stop").
1-44
SINUMERIK 840D/840Di/810D Programming Guide Cycles (PGZ) – 11.02 Edition
1
12.97
09.01
© Siemens AG, 2002. All rights reserved