Interfaces - Siemens SINUMERIK 840D Programming Manual

3
Milling Cycles
3.17 High Speed Settings – CYCLE832 (SW 6.3 and higher)

3.17.4 Interfaces

G codes
List of the G commands programmed in CYCLE832:
• G64, G641, G642
• G601
• FFWON, FFWOF
• SOFT, BRISK
• COMPCAD, COMPCURV,COMPOF,B-SPLINE
• TRAORI, TRAORI(2),TRAOFOF
• UPATH
Note: The G commands should not be generated in the subsequent
CAM program. Technology – Geometry separation.
Machine data
The following machine data is evaluated in cycle CYCLE832:
MD No. MD identifiers
10071 $MN_IPO_CYCLE_TIME – interpolation cycle
20480 $MC_SMOOTHING_MODE
20482 $MC_COMPRESSOR_MODE
20490 MC_IGNORE_OVL_FACTOR_FOR_ADIS
The following machine data is rewritten in cycle CYCLE832:
MD No. MD identifiers
33100 COMPRESS_POS_TOL[AX]
33100 COMPRESS_POS_TOL[AX]
32310 MAX_ACCEL_OVL_FACTOR[AX]
32310 MAX_ACCEL_OVL_FACTOR[AX]
1) as per 5-axis transformation machine data
Setting data
List of setting data rewritten in CYCLE832:
SD no. SD identifier
42465 $SC_SMOOTH_CONTUR_TOL
42466 $SC_SMOOTH_ORI_TOL
42475 $SC_COMPRESS_CONTUR_TOL
42476 $SC_COMPRESS_ORI_TOL
42477 $SC_COMPRESS_ORI_ROT_TOL
1) The efficiency of setting data $SC_SMOOTH_CONTUR_TOL and
$SC_SMOOTH_ORI_TOL depends on MD20480: $MC_SMOOTHING_MODE.
The efficiency of setting data $SC_COMPRESS_CONTUR_TOL and
$SC_COMPRESS_ORI_TOL depends on MD20482: $MC_COMPRESSOR_MODE
3-268
Comments
Comments
Geometry axes 1...3
Rotary axes 1 and 2
Geometry axes 1...3
Rotary axes 1 and 2
Comments
Corresp. to the tolerance of the linear axes
Corresp. to the tolerance of the rotary axes
for COMPCURV only
for COMPCURV only
for COMPCURV only
SINUMERIK 840D/840Di/810D Programming Guide Cycles (PGZ) – 11.02 Edition
3
12.97
11.02
1)
1)
© Siemens AG, 2002. All rights reserved