Siemens SINUMERIK 840D Programming Manual page 14

0 0
Preface 11.02
Proper use
Principle
Your SIEMENS 810D and 840D have been designed
and constructed to the latest standards of
technology and recognized safety rules, standards
and regulations.
Additional equipment
The applications of SIEMENS controls can be
expanded by adding special additional devices,
equipment and expansion units supplied by
SIEMENS.
Personnel
Only authorized and reliable personnel who have
been trained in the use of the equipment may be
allowed to handle the control. Nobody without the
necessary training must be allowed to operate the
control, even temporarily.
The corresponding responsibilities of personnel
who set up, operate and maintain the equipment
must be clearly defined and adherence to these
responsibilities monitored.
Behavior
Before the control is started up, the personnel who
are to work on the control must be thoroughly
acquainted with the Operator's Guides. The
operating company is also responsible for
constantly monitoring the overall technical state of
the control (noticeable faults and damage, altered
service performance).
Servicing
Repairs must be carried out by personnel who are
specially trained and qualified in the relevant
technical subject according to the information
supplied in the service and maintenance guide. All
relevant safety regulations must be followed.
ã Siemens AG, 2002. All rights reserved
0-14
SINUMERIK 840D/840Di/810D Programming Guide Cycles (PGZ) – 11.02 Edition