New Form Of Delivery For Cycles In Hmi Advanced - Siemens SINUMERIK 840D Programming Manual

1
12.97
11.02

1.7.3 New form of delivery for cycles in HMI Advanced

As from HMI Advanced 6.3, the delivery form of
standard cycles in the HMI will change. The cycle files
will no longer be stored directly in the relevant data
management directories, but will be available as archive
files under:
à Archives/Cycle archives.
This will enable the previously existing cycle version in
data management to be retained unchanged when the
HMI is upgraded.
To upgrade, these archive files must be read in via
"Data in". If these archive files are read in, after the
upgrade there are no longer different versions of the
cycles in the NCU and on the hard disk. The loaded
cycles are overwritten in the NCU, not loaded on the
hard drive. The new cycle files are always stored on the
hard disk.
References: for current infos see:
•
the file "siemensd.txt" from the delivery software (standard cycles) or
•
for HMI Advanced, F:\dh\cst.dir\HLP.dir\siemensd.txt.
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Programming Guide Cycles (PGZ) – 11.02 Edition
1.7 Cycle startup (SW 6.2 and higher)
1
General
1-55