Performing A Pc Calibration; Performing A Video Calibration - Christie HS 2K Series Service Manual

Performing a PC calibration

To perform the PC calibration, complete the steps below.
ID Part name
1 Test equipment
2 Test signal
3 Test pattern
4 Inspection item
1. On the IR remote keypad, press Menu and select Size & Position > Size Presets > Full
Size.
2. Enter Service mode.
See Entering Service mode
3. Select ADC Calibration.
4. Press Enter.
After a few seconds, the ADC calibration status changes from Doing to Done.

Performing a video calibration

To perform the video calibration, complete the steps below.
ID Part name
1 Test equipment
2 Test signal
3 Test pattern
4 Inspection items
1. On the IR remote keypad, press Menu and select Size & Position > Size Presets > Full
Size.
HS Series 2K Service Manual—D13HD2-HS, D13WU2-HS, D16HD-HS, D16WU-HS, D20HD-HS, D20WU-HS
020-001468-02 Rev. 1 (01-2020)
Copyright ©2020 Christie Digital Systems USA Inc. All rights reserved.
Description
Video generator (output level: 700 mv)
Timing: 800 x 600 @60Hz
16 Gray
Check if the ADC calibration status has changed from Doing to Done.
on page 19.
Description
Video generator (output level: 700 mv)
• D20HD-HS, D16HD-HS,D13HD2-HS; Analog 1920 x 1080 @60Hz
• D20WU-HS, D16WU-HS,D13WU2-HS; Analog 1920 x 1200 @60Hz
SMPTE BAR
Check if the ADC calibration status has changed from Doing to Done.
Service setups
24