Omron FH Series User Manual page 323

Item
Layout
RUN signal out
Output
The operation of the output signals in each state is as follows. Set it as necessary.
State
Output condition for
output signal
*1. In the default setting, the check box of the Output for layout 1 and 8 is not displayed.
FH/FHV Series Vision System User's Manual (Z365-E1)
Setting value
[Factory default]
0 to 32 characters Layout name
• The RUN signal is turned on when the box is checked.
Checked
•
[Unchecked]
•
Sets whether or not to output the execution results of the Re-
[Not control]
•
sult output processing units.
ON
•
•
Not control:
OFF
The state of the outputs that were in effect before the lay-
out was changed is retained. If Output is selected just be-
fore the layout is changed, the outputs stay ON, and if
Output is not selected, the outputs stay OFF.
•
ON:
Data is output when a Results output processing unit is
executed in the measurement flow during execution of a
measurement.
•
OFF:
Data is not output even when a Results output processing
unit is executed in the measurement flow for a measure-
ment.
Layout 0, 2 to 7 dis-
*1
played
Follow the Output setting
in the measurement win-
dow.
Description
Just after switching
scenes /layouts
Follow Output on Follow the setting of
Layout setup dialog. Startup layout of Basic
on System Settings in
Tool menu.
For the selected layout in
the Layout setup dialog,
the output is not per-
formed when the Output
setting is No Control.
8 Setting Windows
At startup
8 - 23
8