Program 92 : Copy Program; Copy Program - NEC SL1000 Programming Manual

SL1000
Level
IN
Description
Program
(This program is available only via telephone programming and not through PC Programming).
92
Use Program 92-01 : Copy Program to copy the data for one program to another multiline terminal,
port, group, or other number. Refer to the following charts to see which programs can be copied.
Input Data
Item No.
01
The Copy Program is applicable only for the following programs:
Trunk Port Base
Program No.
14-01
14-02
14-04
14-08
14-09
20-30
21-03
21-12
21-21
21-22
22-02
22-03
22-05
22-08
31-05
2-548
Program Number
Item
Source Number
Enter the extension, trunk, group or other number from which the
data is to be copied.
Destination Number (From)
Enter the first extension, trunk, group or other number to which
the information is to be copied.
Destination Number (To)
Enter the last extension, trunk, group or other number to which
the information is to be copied. If the information is being copied
only to one extension, trunk, group or other number, enter the
information entered in the Destination Number (From) entry.
Program Name
Trunk Basic Data Setup
Analog Trunk Data Setup
Behind PBX Setup
Music on Hold Source for Trunks
Conversation Recording Destination for Trunk
Timer Class for Trunk
Trunk Group Routing for Trunks
ISDN Calling Party Number Setup for Trunk
Toll Restriction for Trunks
CO Message Waiting Indication
Incoming Service Type Setup
Trunk Ring Tone Setup
IRG Assignment for Normal Ring Trunk
Second IRG Setup for Unanswered DIL / IRG
Incoming Ring Tone Audible on External Speaker

Program 92 : Copy Program

92-01 : Copy Program

Copy all data except Trunk Name(Item 01).
Issue 0.1
XX-XX
Input Data
• For Trunk Base :Trunk Port
Number
1~142
• For Trunk Group Base :Trunk
Group Number 1~25
• For Extension Base :Extension
Number
(Up to four digits)
• For Department Group Base
:Department Group Number 1~32
• For DSS :DSS Console Number
1~12
• For Door Phone: Door phone
number: 1~8
Note
Program 92 : Copy Program