NEC SL1000 Programming Manual page 106

SL1000
Item No.
09 Private Line
10 DTMF Tones for Outgoing Calls
Use this option to enable (1) or
disable (0) DTMF tones for
outgoing trunk calls.
11 Account Code Required
Program
12 --- Not Used ---
14
13 Trunk-to-Trunk Transfer
Use this option to enable (1) or
disable (0) loop supervision for the
trunk. This option is required for
Call Forwarding Off-Premise and
Tandem Trunking only.
14 Long Conversation Cutoff
Use this option to enable or disable
the Long Conversation Cutoff
feature for each trunk.
15 Long Conversation Alarm Before
Cutoff
Use this option to enable or disable
the Long Conversation Alarm for
each trunk.
16 Forced Release of Held Call
Use this option to enable/disable
forced release for calls on Hold. If
enabled, the system disconnects a
call if it is on Hold longer than a
programmed interval (Program
24-01-05). If disabled, forced
disconnection does not occur.
Program 24-01-01 also affects this
option.
17 Trunk to Trunk Warning Tone for
Long Conversation Alarm
Use this option to enable or disable
the Warning Tone for Long Conver-
sation feature for DISA callers.
18 Warning Beep Tone Signaling
19 Privacy Mode Toggle Option
Use this option to enable or disable
a trunk ability to be switched from
private to non-private mode by
pressing the line key or Privacy
Release function key.
20 Block Outgoing Caller ID
Allow (1) or prevent (0) the system
from automatically blocking
outgoing Caller ID information
when a user places a call. If
allowed (i.e. block, enabled), the
system automatically inserts the
Caller ID block code (defined in
14-01-21) before the user dialed
digits.
21 Caller ID Block Code
Enter the code, up to 8 digits, that
should be used as the Caller ID
Block Code. This code is automati-
cally inserted before dialed digits if
Program 14-01-20 is set to 1.
2-86
Item Input Data
0 = Disable Private Line
(Normal)
1 = Enable Private Line
(Private Line)
0 = Disable (No)
1 = Enable (Yes)
0 = Disable (No)
1 = Enable (Yes)
0 = Disable (No)
1 = Enable (Yes)
0 = Disable (No)
1 = Enable (Yes)
0 = Disable (No)
1 = Enable (Yes)
0 = Disable (No)
1 = Enable (Yes)
0 = Disable (No)
1 = Enable (Yes)
0 = Disable (No)
1 = Enable (Yes)
0 = Disable (No)
1 = Enable (Yes)
0 = Prevent (No)
1 = Allow (Yes)
Dial (up to eight digits)
Related Pro-
Default
gram
0
1
1
0
0 20-21-03
20-21-04
0 20-21-01
20-21-02
0 24-01-01
24-01-05
0
0
0
0 14-01-21
20-08-15
No Setting 14-01-20
20-08-15
Program 14 : Trunk, Basic Setup
Issue 0.1