NEC SL1000 Programming Manual page 485

Issue 0.1
Item No.
32 DTMF Relay Mode
Determine the DTMF setup.
33 G.722 Audio Frame
Maximum number of G.722 Audio Frames. G.722
assumes the audio signal made by a specimen by
16kHz and the frame of 10ms is assumed to be a
unit to 64kbps by the encoding compressed method.
34 G.722 Silence Compression Mode
Select whether to compress silence with G.722.
When there is silence, the RTP packet is not sent.
35 G.722 Jitter Buffer - Minimum
Set the minimum value of the Jitter Buffer of G.722
is set. Jitter is the variation in the time between
packets arriving and the buffer allows this variation
to be absorbed.
36 G.722 Jitter Buffer - Standard
Set the average G.722 Jitter Buffer.
37 G.722 Jitter Buffer - Maximum
Set the maximum G.722 Jitter Buffer.
38 G.726 Audio Frame
Maximum number of G.726 Audio Frames. G.726
assumes the audio signal made by a specimen by
16kHz and the frame of 10ms is assumed to be a
unit to 32kbps by the encoding compressed method.
39 G.726 Silence Compression Mode
Select whether to compress silence with G.726.
When there is silence, the RTP packet is not sent.
40 G.726 Jitter Buffer - Minimum
Set the minimum value of the Jitter Buffer of G.726
is set. Jitter is the variation in the time between
packets arriving and the buffer allows this variation
to be absorbed.
41 G.726 Jitter Buffer - Standard
Set the average G.726 Jitter Buffer.
42 G.726 Jitter Buffer - Maximum
Set the maximum G.726 Jitter Buffer.
43 iLBC Audio Frame
Maximum number of iLBC Audio Frames. iLBC
assumes the frame of 10ms is a unit.
44 iLBC Silence Compression Mode
Select whether to compress silence with iLBC. When
there is silence, the RTP packet is not sent.
45 iLBC Jitter Buffer - Minimum
Set the minimum value of the Jitter Buffer of iLBC is
set. Jitter is the variation in the time between
packets arriving and the buffer allows this variation
to be absorbed.
46 iLBC Jitter Buffer - Standard
Set the average iLBC Jitter Buffer.
47 iLBC Jitter Buffer - Maximum
Set the maximum iLBC Jitter Buffer.
48 ILBC Payload Number
The payload number of iLBC is set. However, the
same number as Item 31 cannot be set.
49 RTP Filter
50 Fax Relay mode
51 T.38 Protocol mode
Programming Manual
Item
0 = Disable
1 = RFC2833
1 = 10 ms
2 = 20 ms
3 = 30 ms
4 = 40 ms
0 = Disable
1 = Enable
0~255 ms
0~255 ms
0~255 ms
1 = 10 ms
2 = 20 ms
3 = 30 ms
4 = 40 ms
0 = Disable
1 = Enable
0~255 ms
0~255 ms
0~255 ms
2 = 20 ms
3 = 30 ms
4 = 40 ms
0 = Disable
1 = Enable
0~255 ms
0~255 ms
0~255 ms
96-127
0 = Disable
1 = Enable
0 = Disable
1 = Enable
0 = RTP
1 = UDPTL
Input Data Default
SL1000
0
3
0
Program
30
84
60
20
3
0
30
60
120
3
0
30
60
120
98
0
0
1
2-465