Setting Output Range Mode; Performing Measurement; Available Application Test List - Keysight Technologies B1505A User Manual

Measurement Examples
Using Multiple HVSMU Modules

Setting Output Range Mode

You can set the output range mode of the HVSMU by either of the following:
•
•
For the HVSMUOP command, see Keysight B1500 Programming Guide.
The application test Switch HVSMU Output Mode belongs to the MultiHVSMU
category. For details of this application test, see the help message for each test
definition.

Performing Measurement

1. Open the application test Switch HVSMU Output Mode, and specify the output
2. Click the
3. Open the test definition or setup for a measurement, and specify the
4. Click the
Automation from the mode setup to the measurement is available by using the
Quick Test.
If the output setting in your test setup is over the output range of the specified mode,
the error 105001 occurs during the measurement. In this case, check the
measurement condition and set the output range mode and the condition properly.

Available Application Test List

Category
MultiHVSMU Switch HVSMU Output Mode
5-46
Performing the HVSMUOP command using the classic test Direct Control
Performing the setup using the application test Switch HVSMU Output Mode
range mode.
Single button to set up the HVSMU output range mode.
measurement conditions.
Single button to start the measurement.
Application Test Description
Switching HVSMUs output range mode
Keysight B1505A User's Guide, Edition 12