Keysight Technologies B1505A User Manual page 117

6. Blank PTFE Board (N1259A-012)
Figure 3-5 Blank PTFE Board
Keysight B1505A User's Guide, Edition 12
This is an insulation board used for placing a DUT.
To use this board, see the following simple instruction.
a. Prepare a DUT, wire (N1254A-508 or 509), and dolphin clip adapter
(N1254A-510) or cable lug adapter (N1254A-511).
b. Attach the blank PTFE board to the test fixture.
c. Connect adapters directly to the DUT and put it on the blank PTFE board.
d. Connect wires between the adapters and the fixture output terminals.
For making the Kelvin connection, Force and Sense must be connected
together at the device terminal.
If MCSMU, HCSMU, or DHCSMU is used, High Force and Sense must be
connected to the high terminal of a device under test (DUT). Low Force,
Low Sense, GNDU Force, and GNDU Sense must be connected to the low
terminal of the DUT.
e. Make sure the DUT location. The DUT must be placed on the blank PTFE
board properly.
Accessories
3-21