Keysight Technologies B1505A User Manual page 243

WARNING
Table 5-1
B1505A
Output
Terminal
GNDU GNDU Cable
Interlock Interlock Cable
To prevent electrical shock and DUT damage, do not connect or disconnect the
DUT while the instrument is applying voltage or current.
When you touch the DUT after measurement, devise a countermeasure of
residual charge and heat to prevent electrical shock and burn. Use gloves and
any tool. Also have enough time for discharge and radiation.
Afin d'éviter toute décharge électrique et dommage MST, ne branchez ou
débranchez pas la sortie MST alors que l'appareil envoie de la tension ou du
courant.
Lorsque vous touchez le MST après la mesure, élaborez une contre-mesure de
la charge résiduelle et du chauffage afin d'éviter tout choc électrique et toute
brûlure. Utilisez des gants et des outils. Prévoyez également du temps pour la
décharge et la radiation.
Prepare a measurement as follows:
1. Connect the test fixture, the socket module, and the required accessories.
For more information, see the following sections:
• "N1272A Device Capacitance Selector" on page 3-83
• "N1273A Capacitance Test Fixture" on page 3-87
The GNDU and the Interlock must be connected to the test fixture or the prober
station actually used for the measurement. See
measurement connection, and see
2. Prepare a DUT (device under test).
3. Turn the N1272A selector on, and then turn the B1505A on.
Do not connect the device at this time.
Connections for the Capacitance Measurement
Cable
Input
Terminal
GNDU
Interlock
Keysight B1505A User's Guide, Edition 12
I-V and Capacitance Measurements Using N1272A
Table 5-2
N1272A
Output
Terminal
Interlock Interlock Cable
Measurement Examples
Table 5-1 for the capacitance
for the IV measurement connection.
N1273A or
Prober Station
Cable
Input Terminal
Interlock
5-25