Keysight Technologies B1505A User Manual page 168

Accessories
For the setup image, see the following figure.
Inside View
Magnets
See the following simple instruction.
1. (First time only) Attach protective films (N1271-25015) on the surfaces of two
magnets on the back of hood's front panel.
2. Remove the socket module from the test fixture and set the base plate on the
DUT stage of the test fixture instead.
3. Place the Thermal Plate on the base plate.
4. Connect the cable from the Thermal Plate to the Thermal plate adapter.
5. Connect the ground wire from the Thermal plate adapter to the ground terminal
on the base plate.
6. Put your DUT on the Thermal Plate.
7. Connect your DUT properly. Then use the test leads furnished with this option.
8. (for N1265A) If you use the thermocouple, do the following.
a. Connect the thermocouple to the K Thermocouple terminal.
b. Secure the end of the thermocouple to the place for monitoring temperature.
3-72
Thermal Test Hood
Thermal plate adapter
Keysight B1505A User's Guide, Edition 12
Base plate
Thermal plate