Keysight Technologies B1505A User Manual page 33

NOTE Keysight B1505A has the following front panel user interface.
• Stop
Stops the present measurement or source output immediately.
• Rotary knob
Rotating the knob moves the marker on the graph window, or
increases/decreases/changes the value in the active entry field.
Pressing the knob sets or enters the value.
• Softkeys
Seven softkeys are available. Used to select one for the entry field specified or
the dialog box. They are also used to recall the test definitions (pre-defined test
setups).
• Touch Panel Off
Enables or disables the touch screen operation.
• Standby switch
Turns the B1505A on. Pressing the button in the ON state makes the B1505A in
the standby state.
• LCD Off
Enables or disables the LCD panel. LED lights when the LCD is disabled.
• +, -, Set, Cancel
Four keys are available for adjusting brightness. Use + and - to adjust it and
then press Set to fix it. Pressing Cancel instead of Set cancels the adjustment.
Keysight B1505A also requires Keysight EasyEXPERT software as its graphical
user interface. You can operate Keysight EasyEXPERT by using the touch panel.
Use your fingers, stylus pen, and so on for the touch panel operation. The USB
keyboard and the USB mouse are also available for operating the EasyEXPERT.
To remove USB devices from the B1505A, use "Safely Remove Hardware" on
Windows taskbar. If it is not used, the B1505A may cause the internal USB
communication error. If the error occurs, turn the B1505A off and disconnect the
power cable from the B1505A. Leave it about 30 seconds before rebooting the
B1505A, and connect the power cable again, and then turn the B1505A on.
Keysight B1505A User's Guide, Edition 12
Getting Started
To Turn On/Off B1505A
1-5