Siemens SCALANCE W1750D CLI Function Manual page 67

Most modems using a 4G driver will automatically select the best available cellular network
coverage based on the RSSI value.
Note
When UML290 runs in auto detect mode, the modem can switch from 4G network to 3G
network or vice-versa based on the signal strength. To configure the UML290 for the 3G
network only, manually set the USB type to pantech-3g. To configure the UML290 for the 4G
network only, manually set the 4G USB type to pantech-lte.
Example 1
The following example configures a cellular uplink profile:
(scalance)(config) # cellular-uplink-profile
(scalance)(cellular-uplink-profile)# usb-type sierra-net
(scalance)(cellular-uplink-profile)# usb-dev 0x0f3d68aa
(scalance)(cellular-uplink-profile)# usb-init 3,broadband
(scalance)(cellular-uplink-profile)# end
(scalance)# commit apply
Example 2
The following example configures a cellular uplink profile for UML295 Country US and ISP
Pantech:
(scalance)(config) # cellular-uplink-profile
(scalance)(cellular-uplink-profile)# usb-type rndis-uml295
(scalance)(cellular-uplink-profile)# usb-dev 0x10a96064
(scalance)(cellular-uplink-profile)# usb-tty ttyACM0
(scalance)(cellular-uplink-profile)# end
(scalance)# commit apply
Command Information
AP Platform
All platforms
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
Command Mode
Configuration mode and cellular uplink profile configuration sub-mode
CLI Commands
4.3 C
67