Siemens SCALANCE W1750D CLI Function Manual page 481

Syntax
show distributed-dhcp-branch-counts <type> <sip> <eip>
Parameter
type
<sip>
<eip>
Usage Guidelines
Use this command to view branch details for the distributed DHCP scopes.
Example
The following example shows the output of the show distributed-dhcp-branch-counts
command:
Branch Count Table
------------------
Client Count Upto
------------
1
2
3
7
The output of this command displays the following information:
Parameter
Client Count Upto
Branch Count
Command Information
AP Platform
All platforms
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
Description
Displays the branch details for the distributed DHCPs based on the type of
the DHCP scope specified. The current release of Scalance W supports the
following distributed DHCP assignment modes.
Distributed, L2
•
Distributed, L3
•
Filters the branch count information based on an IP address range specified
for the starting IP address <sip> and ending IP address parameters. You
can specify up to four different ranges of IP addresses to filter the command
output.
Branch Count
-----------------
10
4
3
1
Description
Displays the number of clients allowed for each DHCP branch.
Displays the number of branches allowed for the specified range of IP ad-
dresses.
Command Mode
Privileged EXEC mode
CLI Commands
4.16 S
481