Siemens SCALANCE W1750D CLI Function Manual page 673

Command/Parameter
uplink
<types>]]}
captive-portal-proxy-
server
<ip> <port>
content-filtering
deny-inter-user-
bridging
deny-local-routing
disable
dmo-channel- utiliza-
tion-threshold
<threshold>
dot11k
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
Description
You can also exclude an uplink type for
the captive portal based SSID profiles.
When an uplink type is selected for the
exclude-uplink option, redirection to the
captive portal based on the type of
specified uplink is disabled.
Allows you to specify an IP address and
port number that match the proxy con-
figuration of your browser.
Routes all DNS requests for the non-
corporate domains to OpenDNS on this
network.
Disables the bridging traffic between
two clients connected to the same SSID
on the same VLAN. When inter-user
bridging is disabled, the clients can
connect to the Internet, but cannot
communicate with each other, and the
bridging traffic between the clients is
sent to the upstream device to make the
forwarding decision.
Disables the routing traffic between two
clients connected to the same SSID on
different VLANs. When local routing is
disabled, the clients can connect to the
Internet, but cannot communicate with
each other, and the routing traffic be-
tween the clients is sent to the upstream
device to make the forwarding decision.
Disables the SSID. By default all SSIDs
are enabled.
Sets a threshold for DMO channel utili-
zation. AP sends multicast traffic over
the wireless link.
Enables 802.11k roaming on the SSID
profile.
The 802.11k protocol enables APs and
clients to dynamically measure the
available radio resources.
When 802.11k is enabled, APs and
clients send neighbor reports, beacon
reports, and link measurement reports
to each other.
CLI Commands
Range Default
3G,4G, —
wifi,ethernet
— —
— Disabled
— —
— —
— —
1–100 percentage 90
value
— —
4.20 W
673