Table of Contents
Advertisement
CLI Commands
4.16 S
Parameter
MAC Address
Description
Access Point
Table 11:
Type
code
1
2
3
4
262
Description
Displays the MAC address of the client that caused the alert.
Displays the description code for the alert. For example, Type 5 and
Description 11 indicates that the DHCP request has timed out and the
client did not receive a response to its DHCP request in time. For more
information, see Table 11.
Displays the IP address of the AP to which the client is connected.
Client Alert —Type and Description Codes
Description
Code
Detailed Description
1
Internal error
The AP has encountered an internal error for this client.
2
Unknown SSID in association request.
The AP cannot allow this client to associate because the association request
received contains an unknown SSID.
3
Mismatched authentication/encryption setting
The AP cannot allow this client to associate because its authentication or
encryption settings do not match the configuration of the AP.
4
Unsupported 802.11 rate
The AP cannot allow this client to associate because it does not support the
802.11 rate requested by this client.
5
Maximum capacity reached on AP
The AP has reached maximum capacity and cannot accommodate any more
clients.
6
Invalid MAC Address
The AP cannot authenticate this client because its MAC address is not valid.
7
Client blocked due to repeated authentication failures
The AP is temporarily blocking the 802.1x authentication request from this
client because the credentials provided have been rejected by the RADIUS
server too many times.
8
Authentication server timeout
The AP cannot authenticate this client using 802.1x because the RADIUS
server did not respond to the authentication request. If the AP is using the
internal RADIUS server, recommend checking the related configuration as
well as the installed certificate and passphrase.
9
RADIUS server authentication failure
The AP cannot authenticate this client using 802.1x because the RADIUS
server rejected the authentication credentials provided by the client.
10
Integrity check failure in encrypted message
The AP cannot receive data from this client because the integrity check of the
received MIC has failed. Recommend checking the encryption setting on the
client and on the AP.
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
Advertisement
Table of Contents
