Table of Contents
Advertisement
The client list in the command output for both wireless and wired clients provides the
following information:
Column
Name
IP address
MAC address
OS
Network
Access Point
Channel
Type
Role
Signal
Speed(Mbps)
show clients <diff>
The show clients <diff> command displays the change in the clients table data that occurred
during the specified interval. For example, if the value specified for <diff> parameter is 10
seconds, the client table displays the changes such as signal strength or speed that
occurred since the last 10 seconds.
show accounting <mac>
The show accounting <mac> command displays the accounting information such as status
and session ID for a specific client MAC address.
show checksum <mac>
The following output is displayed for the show checksum <mac> command:
Mac Address:08:ed:b9:e1:51:7d Basic info
----------
mac
---
08 ed b9 e1 51 7d bssid
d8 c7 c8 3d 3d 52 ap_ip
0a 11 58 ba name
00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
00 00 00 00 00
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
Description
Displays the name of the client
Displays the IP address of the client.
Displays the MAC address of the client.
Indicates the OS running on the client system.
Indicates the SSID and network to which the client is connected.
Indicates the IP address of the Access Point to which the client is connect-
ed.
Indicates the channel assigned to the client.
Indicates the type of the Wi-Fi client device.
Indicates the role assigned to the client.
Indicates the current signal strength of the client, as detected by the AP.
Indicates the current speed at which data is transmitted. When the client is
associated with an AP, it constantly negotiates the speed of data transfer. A
value of 0 means that the AP has not received any packets from the client
for some time.
CLI Commands
4.16 S
425
Advertisement
Table of Contents
