Table of Contents
Advertisement
CLI Commands
4.16 S
Example
The following example shows the output of show gre status command:
GRE Tunnel Status
-----------------
Active Tunnel : Primary (2000:172:16:168::1) created at 2018-11-08 12:39:21
Uptime of the Tunnel :34 days 4 hours 48 minutes 53 seconds
GRE Tunnel status :Up
Next inactivity check :0 (sec)
Total Ping sent 0
Total Ping missed 0
Next Ping packet after :8 (secs)
Expired Hold on Time :0 (sec)
The output of this command provides the following information:
Parameter
Active Tunnel
Uptime of the Tunnel
GRE Tunnel status
Next inactivity check
Total Ping sent
Total Ping missed
Next Ping packet after
Expired Hold on Time
Command Information
AP Platform
All platforms
504
Description
Displays the current tunnel with its creation date and time.
Displays the uptime of the current tunnel.
Denotes if the tunnel is up or down.
Displays the counter for tunnel inactivity check, which indicates
when to start another counter for next ping to send. If there is no
reply, its value is 0; if there is reply, its value is 10. This starts from
10 and decreases to 0. When the value is 0, the counter Next Ping
packet after starts to decrease from 10 to 0.
Denotes the ping packets sent.
Denotes the number of ping packets missed out of ping packets
sent.
Displays the counter for the next ping packet. By default the value
is set to 10, and will start decreasing when Next inactivity check is
equal to 0. When the value for the Next Ping packet after is 0, the
value of Total Ping sent is incremented.
Displays the counter for hold on time check. This is 0 if current
endpoint is primary. If endpoint is backup, the value starts increas-
ing. When it reaches its upper limit, the ping to primary is done and
accordingly the tunnel endpoint is changed.
Command Mode
Privileged EXEC mode
Function Manual, 03/2019, C79000-G8976-C452-04
SCALANCE W1750D CLI
Advertisement
Table of Contents
