Table of Contents
Advertisement
L3 Mobility Events
------------------
Time Client MAC Event IP Dir
---- ---------- ----- -- ---- May 9 23:26:29 08:ed:b9:e1:51:87 Station Offline
10.17.88.59 <-
May 9 23:26:29 08:ed:b9:e1:51:87 Potential Foreign Client10.17.88.59 <-
May 9 23:09:05 08:ed:b9:e1:51:87 This Client is Normal 10.17.88.59 ->
Peer IP Home Vlan VAP Vlan Tunnel ID Old AP IP FAP IP HAP IP VC IP Additional Info
---- ---------- -------- ------- --------- -------- ----- ---- ---------
self - 1 - - - - - -
self - - - - - - - -
self - 1 - - 10.17.88.59 - l2-timed-out,test
The output of this command provides the following information
Parameter
Time
Client MAC
Event
IP
Dir
Peer IP
Home Vlan
VAP Vlan
Tunnel ID
Old AP IP
FAP IP
HAP IP
VC IP
Additional Info
show l3-mobility status
The following example shows the output of the show l3-mobility status command:
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
Description
Indicates the timestamp of the L3 mobility event.
Indicates the MAC address of the roaming clients.
Provides a description of the mobility event.
Indicates the IP address of the roaming client.
Indicates if the client has roamed in or out of the mobility subnet.
Displays the peer IP address, if any peer clients are configured.
Displays the VLAN ID associated with the home subnet.
Displays the VLAN ID associated with the Virtual AP.
Indicates the tunnel interface used for routing packets.
Indicates the IP address of the AP from which the client has roamed.
Indicates the IP address of the AP in the foreign subnet.
Indicates the IP address of the AP in the home subnet, to which the client is
currently connected.
Indicates the IP address of the Virtual Controller.
Displays additional information if any.
CLI Commands
4.16 S
525
Advertisement
Table of Contents
