Siemens SCALANCE W1750D CLI Function Manual page 698

Simatic net industrial wireless lan
Table of Contents

Advertisement

CLI Commands
4.20 W
Parameter
<match>
<protocol>
<sport>
<eport>
dst-nat
src-nat [vlan <vlan
id>|tunnel]
<dst-nat-IP-address>
<dst-nat-port>
app <app>
appcategory <appgrp>
webcategory <webgrp>
698
Description
match — Indicates if the rule specific to the des-
tination IP address and subnet mask matches the
value specified for protocol.
invert — Indicates if the rule allows or denies
traffic with an exception to the specified destina-
tion IP address and subnet mask.
Configures any of the following:
Protocol number between 0-255
any: any protocol
tcp: Transmissio n Control Protocol
udp: User Datagram Protocol
Specifies the starting port number from which the
rule applies.
Specifies the ending port number until which the rule
applies
Allows the AP to perform des- tination NAT on pack-
ets.
Allows the AP to perform source-NAT on packets.
When configured, the source IP changes to the out-
going interface IP address (implied NAT pool) or from
the pool configured (manual NAT pool).
vlan - All client based traffic will be directed to the
specified uplink VLAN using the IP address of the
interface that AP has on that VLAN; if the interface is
not found, this option has no effect.
tunnel- The traffic from the Network Assigned clients
is directed to the VPN tunnel.
Specifies the destination- NAT IP address for the
specified packets when dst-nat action is configured.
Specifies the destination- NAT port for the specified
packets when dst-nat action is configured.
Specifies a rule to allow or deny access to a specific
type of application.
Specifies a rule to allow or deny access to a specific
category of application.
Specifies a rule to allow or deny access to websites
based on website category.
Range
match
invert
1–255
1–65534
1–65534
To view the list of
applications, run
the show dpi app
all command.
To view the list of
application catego-
ries,
run the show dpi
appcategory all
command.
To view the list of
website categories,
run the show dpi
webcategory all
command.
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04

Advertisement

Table of Contents
loading

Table of Contents