Siemens SCALANCE W1750D CLI Function Manual page 151

Parameter
osen
osu-nai
osu-ssid
p2p-cross-
connect
p2p-dev-mgmt
pame-bi
qos-map-excp
qos-map-range
query-response-
length- limit
<len>
release-number
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
Description
Uses the OSEN information element to advertise and
select an OSEN capable network.
NOTE: When OSU ESS is encypted, create a
separate hotspot profile with only osen enabled and
attach it to an SSID that broadcasts OSEN capable
network. Then, choose the operation mode to WPA2-
AES.
Indicates the Network Access Identifier (NAI) that is
used for OSU with the service provider configured in
the OSU provider profile. When the OSU NAI is
configured, the OSU ESS employs a link-layer
encryption. For open OSU ESS, this parameter is not
applicable
Configures the SSID that the wireless devices use for
OSU with all the OSU providers.
Advertises support for P2P Cross Connections.
Advertises support for P2P device management.
Enables the Pre-Association Message Exchange
BSSID Independent (PAME-BI) bit, which is used by
an AP to indicate whether the AP indicates that the
Advertisement Server can return a query response
that is independent of the BSSID used for the GAS
Frame exchange.
Includes the DSCP exceptions in the QoS map set.
You can configure a maximum of 21 sets of DSCP
exception fields. It must be entered in Hexadecimal
format. It is in the format, <value>-<up> separated by
',' where <value> can be 0-3F or FF, and user priority
<up> can be 0-7)
Configures the DSCP range value between 0 and 63
inclusive, or 255. It must be entered in Hexadecimal
format. You must configure 8 sets each
corresponding to a user priority. The format is <low>-
<high> separated by a ',' where low and high are 0-3F
and FF. For Example: 08-0F,00-07, FF-FF,10- 1F,20-
27,FF-FF,28-2F,30-3F
Configures the maximum length of the GAS query
response. GAS enables advertisement services that
allow the clients to query multiple 802.11 networks at
once, while also allowing the client to learn more
about a network's 802.11 infrastructure before asso-
ciating.
If a client transmits a GAS Query using a GAS Initial
Request frame, the responding AP will provide the
query response (or information on how to receive the
query response) in a GAS Initial Response frame.
Indicates the release number of Hotspot.
CLI Commands
Range Default
— Disabled
— —
— —
— Disabled
— Disabled
— —
— —
— —
1 - 6 1
1 - 2 1
4.8 H
151