Siemens SCALANCE W1750D CLI Function Manual page 396

CLI Commands
4.16 S
-------
c8:b5:ad:c3:ac:5c 192.168.1.128* access disable 1 345(indoor)
fe80::cab5:adff:fec3:ac5c N/A - CNDBK5106R 149E 19 51(ok)
-90(good) 52E 12 51(ok) -88(good)
No none 0 12495 enable
20h:22m:48s fe80::cab5:adff:fec3:ac5c
The output of this command includes the following parameters:
Column
Name
IP address
Mode
Spectrum
Client
Type
IPv6 address
Mesh Role
Zone
Serial
2.4 Channel
2.4 Power(dB)
2.4 Utilization
2.4 Noise Floor
5.0 Channel
5.0 Power(dB)
5.0 Utilization
5.0 Noise Floor
Need antenna con-
fig
From port
Config Id
Config Csum
Ext SSID Active
Age
Link Local IP
Address
The following output is displayed for the show aps scanning command:
AP Scanning Stats
-----------------
Name
----
396
Description
Name of the APs.
IP address of the APs.
Operating mode. For example, access, monitor, or spectrum monitor modes.
Indicates if spectrum monitoring is enabled or disabled.
Indicates the number of client associated with the AP.
Displays the AP model.
IPv6 address of the AP
Indicates if the AP is functioning as Mesh Point or mesh Portal.
Zone name of the AP.
Serial number of the AP.
Channels used by the AP in the 2.4 GHz band.
Transmission power allocated for 2.4 Ghz band channels.
Percentage of utilization of 2.4 GHz channels.
Noise floor of the 2.4 GHz channels.
Channels used by the AP in the 5 GHz band.
Transmission power allocated for 5 GHz band channels.
Percentage of utilization of 5 GHz channels.
Noise floor of the 5 GHz channels.
Indicates if antenna configuration is required.
Indicates the port details if any.
Indicates the configuration ID.
Checksum that is used for configuration sync between master and slave-
access points.
Extended SSID flag that indicates if mesh is enabled.
Active time of the current master AP.
IPv6 link local IP address of the AP.
IP Address 2.4 Reqs 2.4 Voice Rejs 2.4 Video Rejs 5.0 Reqs
---------- -------- -------------- -------------- -----
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04