Table of Contents
Advertisement
CLI Commands
4.7 G
Parameter
primary <name>
backup <name>
disable-preemption
disable-reconnect-
user-on-failover
hold-time
<hold_time>
per-ap-tunnel
ping-frequency
<freq>
ping-retry-count
<new_count>
reconnect-time-on-
failover <down time>
type <type>
no...
Usage Guidelines
Use this command to configure a manual GRE IPv4 or IPv6 tunnel
Example
The following example configures a IPv4 or IPv6 GRE tunnel :
(scalance)(config)# gre primary pendpoint@arubanetworks.com
(scalance)(config)# gre backup sendpoint@arubanetworks.com
(scalance)(config)# gre disable-preemption
(scalance)(config)# gre disable-reconnect-user-on-failover
(scalance)(config)# gre hold-time 600
(scalance)(config)# gre per-ap-tunnel
(scalance)(config)# gre ping-frequency 15
(scalance)(config)# gre ping-retry-count <new_count>
116
Description
Denotes the primary GRE tunnel IP address or
domain name.
Denotes the secondary GRE tunnel IP address or
domain name
Disables the hold on timer from running on the
AP.
Prevents the SSIDs from being disabled when a
GRE tunnel failover occurs.
Configures the hold time for the GRE tunnel fail-
over. When preemption is enabled, and the pri-
mary GRE tunnel is UP, the GRE tunnel
connection will switch to the primary tunnel after
the specified hold time.
Enables allAPs in a cluster to form individual
GRE tunnels to the endpoints. The tunnel failover
will be determined by the Master AP in the clus-
ter. The slave APs will sync its GRE tunnel end-
point to the same endpoint as the master AP to
ensure uniformity in the tunnel endpoint across
the cluster.
Denotes the ping interval.
Denotes the number of ping packets missed to
mark the tunnel down status.
Denotes the time to disable SSIDs.
Configures the protocol number for the GRE type
Removes the configuration.
Range
—
—
—
—
30-900
seconds
—
10-60
seconds
2 - 10
—
—
—
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
Default
—
—
—
—
600 sec-
onds
—
15 seconds
3
—
—
—
Advertisement
Table of Contents
