Siemens SCALANCE W1750D CLI Function Manual page 235

Parameter
free-channel-index
<idx>
legacy-mode
max-distance
<count>
max-tx-power
<power>
min-tx-power
<power>
max-distance
<count>
spectrum-band
<type>
spectrum-monitor
very-high-
throughput-
disable
zone <zone>
no...
Usage Guidelines
Use this command to create a 5 GHz radio profile on an AP.
Example
The following example configures the 5 GHz radio profile:
(scalance)(config)# rf dot11a-radio-profile
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
Description
The difference in the interference index between
the new channel and current channel must ex-
ceed this value for the AP to move to a new
channel. The higher this value, the lower the
chance an AP will move to the new channel.
Recommended value is 25.
Enables the APs to run the radio in non- 802.11n
mode.
When this parameter is set, the radio will still use
the 40 MHz channels even if the 40 MHz intoler-
ance indication is received from another AP or
station.
Configures the maximum transmit power value
for the 5 GHz radio profile.
Configures the minimum transmit power value for
the 5 GHz radio profile.
Configures the maximum distance between a
client and an AP or between a mesh point and a
mesh portal in meters. This value is used to
derive ACK and CTS timeout times.
A value of 0 specifies the default settings for this
parameter, where timeouts are only modified for
outdoor mesh radios which use a distance of
16km.
Allows you to specify the portion of the channel
to monitor for 5 GHz configuration.
Allows the APs in access mode to continue with
normal access service to clients, while perform-
ing additional function of monitoring RF interfer-
ence (from both neighboring APs and non Wi-Fi
sources such as, microwaves and cordless
phones) on the channel they are currently serv-
ing clients.
Disables VHT for clients connecting on the 5
GHz band.
Configures a zone name for the radio profile.
NOTE: This parameter cannot be configured on
a default radio profile.
Removes the configuration.
CLI Commands
4.15 R
Range Default
10-40 25
— Disabled
— Disabled
3 - max 18 dBm
3 - max 12 dBm
600-1000 0
— —
— —
— —
— —
— —
235