Siemens SCALANCE W1750D CLI Function Manual page 522

CLI Commands
4.16 S
Syntax
show l3-mobility {config| datapath| events [<count> <mac>] status}
Parameter
config
datapath
events [<count>
<mac>]
status
Usage Guidelines
Use this command to view the L3 mobility information for an AP.
Example
show l3-mobility config
The following example shows the output of the show l3-mobility config command:
Flags
-----
Type Value
---- -----
Home Agent Load Balancing enable
Virtual Controller Table
------------------------
VirtualRoaming Client Table
--------------------
Client MAC Home Vlan VAP Vlan Tunnel ID Status Virtual Controller IP Peer IP Old AP
IP Device Name
---------- --------- -------- --------- ------ --------------------- ------- --------
- -------
----
Tunnel Table
------------
Peer IP Local Tunnel ID Remote Tunnel ID Use Count Type
------- --------------- ---------------- --------- ----
Virtual Controller Table
------------------------
Virtual Controller IP Type HAP IP Local Tunnel ID Remote Tunnel ID
522
Description
Displays the L3 mobility configuration details for an AP.
Displays the datapath statistics associated with L3 mobility.
Displays L3 mobility events for all AP clients or individual clients filtered
based on MAC address.
Displays the L3 mobility status for an AP.
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04