Esc C 3 N Select Paper Sensor To Output Paper End Signals - SNBC BTP-R580II Programming Manual

[Notes] • This command is enabled only in page mode.
• This command clears print data in the buffer in page mode.
• This command sets the current position to the beginning of the line.
• The page mode area is initialized as default data.
• This command switches the settings of following commands to the values in standard
mode:
①
②
• The following commands can set relevant parameters in standard mode, but the
settings are effective only in page mode:
① Set print area in page mode: ESC W;
② Select print direction in page mode: ESC T.
• The following commands are ignored in standard mode:
① Set absolute vertical print position in page mode:GS $;
② Set relative print position in page mode:GS \.
• Printer returns to standard mode when the printer hardware is reset or command
ESC @ is performed.
[Relative] FF, ESC FF, ESC L

ESC c 3 n Select paper sensor to output paper end signals

[Function] Select paper sensor to output paper end signals.
[Format] ASCII
Hex
Decimal 27
[Range] 0 ≤ n ≤ 255
[Notes] Each bit of n is defined as follows:
Bit
0
1
2
3
4-7
• It is possible to select two sensors to output paper end signals. If any of the sensors
detects paper end, paper end signal will be outputted.
• The command is enabled only in parallel mode and is ignored in serial mode.
• If either bit 0 or bit 1 of n is set to 1, the paper near end sensor is used to output
paper end signal.
• If either bit 2 or bit 3 of n is set to 1, the paper end sensor is used to output paper end
 Set right -side character spacing: ESC SP, FS S
 Select line spacing: ESC 2, ESC 3
ESC c 3
1B 63 33 n
99 51 n
0/1 Hex
0 00
1 01
0 00
1 02
0 00
1 04
0 00
1 08
n
Decimal
0 Paper near end sensor is disabled.
1 Paper near end sensor is enabled.
0 Paper near end sensor is disabled.
2 Paper near end sensor is enabled.
00 Paper end sensor is disabled.
4 Paper end sensor is enabled.
00 Paper end sensor is disabled.
8 Paper end sensor is enabled.
Undefined.
- 64 -
BTP-R580II Programming Manual
Function