SNBC BTP-R580II Programming Manual page 54

K: Kanji
The legal width of the bar: The ratio of the bar is not changeable.
Example:
1D 6B 0B 51 41 2C 30 31 32 33 34 35 36 37 38 39 41 42 43 44 20 32 44 20 63 6F
64 65 00 (Automatic mode is recommended and the character symbol A can be
omitted)
1D 6B 4c 12 48 4D 2C 4E 31 32 33 34 35 36 37 38 39 31 32 33 34 35
1D 6B 0B 4D 4D 2C 41 41 43 2D 34 32 00
1D 6B 0B 4C 4D 2C 4E 30 31 32 33 34 35 36 37 38 39 30 31 32 33 34 35 2C 41 41
42 43 2C 42 30 30 30 36 71 72 63 6F 64 65 00
1D 6B 0B 46 2C 4C 4D 2C 4E 30 31 32 33 34 35 36 37 38 39 2C 41 31 32 41 41 42
42 2C 42 30 30 30 36 71 72 63 6F 64 65 00
▪ When MAXICODE is selected, the length of d1...d k (d1...dn) should not exceed
84 characters and it consists of 5 parts. The format is shown as below:
Legal character: alphabet and numbers;
Length of variable: changeable;
Legal width of barcode: The ratio of the wide and narrow bars is not changeable.
Example:
1D 6B 0C 33 32 37 38 39 35 35 35 35 38 34 30 36 36 36 54 48 49 53 20 50 41 43
4B 41 47 45 49 53 20 47 4F 49 4E 47 20 54 4F 20 44 41 54 41 4D 41 58 43 4F 52
50 2E 00
[Notes ] • n indicates the number of barcode data, and the printer processes n bytes from the
②
next character data as barcode data.
• If n is outside the specified range, the printer stops command processing and
processes the following data as normal data.
[Notes (standard mode)]
• If d is outside the specified range, the command is disabled.
• If the horizontal size of the barcode exceeds print area, the command is disabled.
• The printer feeds as much paper as the barcode height, regardless of the line
spacing specified by ESC 2 or ESC 3.
• This command is enabled only when no data exists in the print buffer. When data
exists in the print buffer, the command is ignored.
• After printing barcode, this command sets the print position to the beginning of the
line.
• This command is not affected by print modes (emphasized, double-strike, underline,
1) The basic postal code in 5 numbers;
2) The second postal code in 4 numbers;
3) The country code in 3 numbers;
4) The service class in 3 numbers;
5) The character strings.
BTP-R580II Programming Manual
- 47 -