①Gs V M ②Gs V M N Select Paper Cutting Mode And Cut Paper; Gs ^ R T M Execute Macro Command - SNBC BTP-R580II Programming Manual

• When GS ^ is received during macro definition, the printer ends macro definition and
clears the definition.
• Macro is not defined when the power is turned on.
• The defined contents of the macro cannot be cleared by ESC @. Therefore, ESC @
can be included in the contents of the macro definition.
• The contents of the macro can be defined up to 2048 bytes. If the macro definition
exceeds 2048 bytes, excess data will be processed as normal data
[Relative] GS ^
GS V m GS V m n
① ②
[Function] Select paper cutting mode and cut paper
[Format] ASCII
①
Hex
Decimal
.ASCII
②
Hex
Decimal
[Range] ① 0 ≤ m ≤ 1, 48≤m ≤ 49
② m = 66, 0 ≤n ≤255
[Notes] Paper cut mode is selected according to the value of m as follows:
0, 48
1, 49
[Notes ] • This command is enabled only when processed at the beginning of the line.
①
[Notes ] • This command is enabled only when processed at the beginning of the line.
②
• m = 0,48,1, 49, printer cuts paper directly.
• When n = 66, the printer feeds paper [distance between print position and cutter + n
× (vertical motion unit) ] and cut paper.
• The horizontal and vertical motion units are specified by GS P.
• Paper feed amount is calculated by vertical motion unit.

GS ^ r t m Execute macro command

[Function] Execute macro command.
[Format] ASCII
Hex
Decimal 29
[Range] 0 ≤ r ≤ 255
0 ≤ t ≤ 255
0 ≤ m ≤ 1
[Notes] • r specifies the times of executing the macro.
• t specifies the waiting time for executing the macro.
Select paper cutting mode and cut paper
GS V m
1D 56 m
29 86 m
GS V m
1D 56 m
29 86 m
m m
0,48 Full cut
1,49 Partial cut
66 66 Feed paper ([n × (vertical motion unit) inches] and partial cut.
GS ^ r
1D 5E r
94 r
n
n
n
Paper cutting mode
t m
t m
t m
- 68 -
BTP-R580II Programming Manual