ESC @ Initialize the printer
[Function]
Initialize the printer, clear data in print buffer and set print mode to the default mode
when powered on.
[Format]
ASCII
Hex
Decimal 27
[Notes]
• The data in the receive buffer is not erased.
• The macro definition is not erased.
• The NV bitmap data is not erased.
ESC L Select page mode
[Function]
Convert from standard mode to page mode.
[Format]
ASCII
Hex
Decimal 27
[Notes]
• This command is enabled only when processed at the beginning of a line in standard
mode.
• This command is disabled in page mode.
• After executing commands FF or ESC S, the printer returns to standard mode.
• This command sets the print position to the position specified by commands ESC T
and ESC W.
• This command converts the settings of following commands to the values in page
mode:
①
②
• The following commands only change flag in page mode, and become effective after
converted to standard mode:
90° clockwise rotation:
①
②
Select character align mo
Select upside
③
Set left space:
④
Set
⑤
• The printer returns to standard mode when power is turned off, the printer is reset, or
ESC @ is performed.
[Relative]
FF, CAN, ESC FF, ESC S, ESC T, ESC W, GS $, GS \
ESC S Select standard mode
[Function]
Select standard mode.
[Format]
ASCII
Hex
Decimal 27
ESC
@
1B
40
64
ESC
L
1B
4C
76
Set right
-side character spacing: ESC SP, FS S
Set line spacing:
ESC 2, ESC 3
-down mode: ESC {
GS L
print area width: GS W
ESC
S
1B
53
83
ESC V
de: ESC a
- 63 -
BTP-R580II Programming Manual