Fs S N1 N2 Set Left-Side And Right-Side Chinese Character Spacing; Fs W N Select/Cancel Quadruple-Size Mode For Chinese Characters - SNBC BTP-R580II Programming Manual

• This command is enabled only in Japanese character mode.
• In JIS code mode, the following character codes are enabled:
First byte: <21>H to <7E>H
Second byte: <21>H to <7E>H
• In SHIFT JIS code mode, the following character codes are enabled:
First byte : <81>H to <9F>H 和 <E0>H to <EF>H
Second byte: <40>H to <7E>H 和<80>H to <FC>H
[Default] n = 0

FS S n1 n2 Set left-side and right-side Chinese character spacing

[Function] Set left-side and right-side Chinese character spacing.
[Format] ASCII
Hex
Decimal 28
[Range] 0 ≤ n1 ≤ 255
0 ≤ n2 ≤ 255
[Notes] Set left-side and right-side Chinese character spacing to n1 and n2 respectively.
• When the printer supports GS P command, the left-side character spacing is [n1 ×
horizontal or vertical motion unit] inches, and the right-side character spacing is [n2 ×
horizontal or vertical motion units] inches.
• When double-width mode is selected, the left- and right-side character spacing is
twice the normal value.
• The horizontal and vertical motion units are set by GS P. The previously specified
character spacing does not change even if the horizontal or vertical motion unit is
changed by GS P.
• In standard mode, the horizontal motion unit is used.
• In page mode, the horizontal or vertical motion unit differs, depending on the starting
position of the printable area as follows:
① When the starting position is set to the upper left or lower right of the print area,
the horizontal motion unit is used;
② When the starting position is set to the upper right or lower left of the print area,
the vertical motion unit is used.
• The maximum right-side Chinese character spacing is approximately 36 mm. Any
setting exceeding the maximum is converted to the maximum automatically.
[Default] n1 = 0, n2 = 0
[Relative] GS P
[Example] Refer to ESC SP

FS W n Select/Cancel quadruple-size mode for Chinese characters

[Function] Select/Cancel quadruple-size mode for Chinese characters.
FS S n1 n2
1C 53 n1 n2
83 n1 n2
BTP-R580II Programming Manual
- 32 -