Gs ! N Select Character Size - SNBC BTP-R580II Programming Manual

[Example] 1B 40
1B 7B 01 (Select upside-down print mode)
41 42 43 44 45 46 0A
30 31 32 33 34 35 0A
1B 7B 00 (Cancel upside-down print mode)
41 42 43 44 45 46 0A
30 31 32 33 34 35 0A
Result:

GS ! n Select character size

[Function] Select character size
[Format] ASCII
Hex
Decimal 29
[Range] 0 ≤ n ≤ 255 (1 ≤enlargement times in vertical direction ≤ 6, 1 ≤enlargement times in
horizontal direction ≤ 6)
[Notes] Select the character height using bit 0 to 3 and select the character width using bit 4 to
7 as follows:
Hex
00
10
20
30
40
50
• This command is effective to all characters (ASCII characters and Chinese), except
for HRI characters.
• If n is outside of the defined range, this command will be ignored.
• In standard mode, the vertical direction is the paper feed direction, and the horizontal
direction is perpendicular to the paper feed direction. However, when character
orientation changes in 90° clockwise-rotation, the relationship between vertical and
horizontal directions is reversed.
• In page mode, vertical and horizontal directions are based on the direction of print
GS ! n
1D 21 n
33 n
Character width selection
Decimal Horizontal enlargement
0 1(normal)
16 2 (double Width)
32 3
48 4
64 5
80 6
BTP-R580II Programming Manual
Character height selection
Hex Decimal
00 0
01 1
02 2
03 3
04 4
05 5
- 27 -
Vertical enlargement
1(normal)
2 (double height)
3
4
5
6