Paper Sensor Replacing - SNBC BTP-M300 Service Manual

Caut tion:
While d isassemblin
cover of f printer;
Please do not drag
breaking g the cable c
Please make sure a
Please avoid squee
During r reassemblin
5 5.1.9 Paper sensor rep
1) 1 Turn off f the power;
2) 2 Disasse emble the pa
3) 3 Remove e the two ST
shown i n the figure
4 4) Install a a new paper
Caut tion:
While d isassemblin
cover of f printer;
Please do not drag
breaking g the cable c
Please make sure a
Please avoid squee
During r reassemblin
ng the lockin ng frame of
g the conne cting cable
connector;
all the cable s connect to
ezing the ca ble in reasse
ng, please fix x all screws
placing
aper cabinet t module acc
T2.6X6 scre ews with cro
;
end sensor r in the rever
ng the lockin ng frame of
g the conne cting cable
connector;
all the cable s connect to
ezing the ca ble in reasse
ng, please fix x all screws
printer, the f force must b
while pullin g the cable
o their socke ets firmly;
embly;
firmly.
cording to st tep 2 and 3
oss screwdr river and dis
rse steps.
printer, the f force must b
while pullin g the cable
o their socke ets firmly;
embly;
firmly.
- 33 -
BT P-M300 Ser
be moderate e to avoid d
out of main n control bo
in section 4 4.2.5;
sassemble t the paper en
be moderate e to avoid d
out of main n control bo
rvice Manu al
damaging th e
oard to avoid d
nd sensor a as
damaging th e
oard to avoid d