Status Commands; Dle Eot N Real-Time Status Transmission - SNBC BTP-R580II Programming Manual

• This command defines n as the number of NV bitmaps. Numbers rise in order from
NV bitmap 1. Therefore, the first data group [xL xH yL yH d1...dk] is NV bitmap 1,
and the last data group [xL xH yL yH d1...dk] is NV bitmap n. It is the same when
printing bitmap using command FS p.
• Define a NV bitmap consisting of [xL xH yL yH d1...dk]. Therefore, when only one NV
bitmap, n=1. The printer uses bytes of Flash memory as follows:
([byte number of bitmap data: (xL + xH × 256) × (yL + yH × 256) × 8] + [header: 4]).
Example is as below: when xL = 64, xH = 0, yL = 96, yH = 0
• Maximum download capacity of Flash is 64K bits (8K bytes). This command can
define several NV bitmaps, but cannot define a bitmap that exceeds 64K bits
(Different printer has different download capacity. Please refer to printer configuration
information).
• When processing this command, printer does not process other commands.
• If this command is received during macro definition, the printer will end macro
definition and begin executing this command.
• Once a NV bitmap is defined, it can not be erased by executing ESC @, reset, and
power off commands.
• This command only defines NV bitmap and does not execute printing. NV bitmap
printing is executed by the FS p command.
[Relative] FS p

2.5 Status commands

DLE EOT n Real-time status transmission

[Function] Real-time status transmission
[Format] ASCII
Hex
Decimal 16
[Range] 1 ≤ n ≤ 4
DLE EOT n
10 04 n
4 n
BTP-R580II Programming Manual
- 39 -