Hex
Decimal 27
[Range]
0 ≤ n ≤ 7
[Notes]
• This command is ignored if the downloaded bitmap has not been defined.
• This command is disabled in upside-down print mode.
• If the downloaded bitmap exceeds the print area, the excess data will not be printed.
• This command prints bitmaps downloaded in RAM, but not bitmaps downloaded in
Flash, and the corresponding bitmap number is specified by GS #.
2.11 Page control commands
ESC c : n Select paper saving mode
[Function]
Select paper saving mode and reduce page length.
[Format]
ASCII
Hex
Decimal 27
[Range]
0 ≤ n ≤ 4
[Notes]
• Paper-saving function refers to vertical compression according to a proportionality
factor set by user to reach the goal of saving paper.
• The command only refers to vertical compression.
• The command only works on compressible space. Compressible space includes:
space between print data (except space caused by space characters); 1D barcode
(The minimal height 1D barcode can be compressed is 30 dots).
• The command compresses compressible space according to a certain proportionality
factor, which is set as follows:
• The command only works on the ticket sending this command.
• This command is enabled only in standard mode.
[Default]
n = 0
2.12 Other commands
DLE ENQ n Real-time request
[Function]
Real-time request
[Format]
ASCII
Hex
Decimal 16
1B
63 37 n
99 55 n
ESC
c
1B
63
99
58
m
Proportionality factor setting
0
1
2
3
4
DLE
ENQ n
10
05
n
5
n
BTP-R580II Programming Manual
:
n
3A
n
n
No compression
Compress 25%
Compress 50%
Compress 75%
Compress 100%
- 60 -