SNBC BTP-R580II Programming Manual page 53

[Notes①] • This command ends with a NUL code.
• When UPC-A or UPC-E is selected, the characters after the first 12 bytes will be
processed as normal characters after receiving12 bytes of barcode data.
• When JAN13 (EAN13) is selected, the characters after the first 13 bytes will be
processed as normal characters after receiving 13 bytes of barcode data.
• When JAN8 (EAN8) is selected, the characters after the first 8 bytes will be
processed as normal characters after receiving 8 bytes of barcode data.
• The number of data for ITF barcode must be even numbers. When an odd number of
data is input, the printer ignores the last received data.
• The beginning code and the ending code of CODEBAR barcode must be one of A, B,
C and D. The ending codes can be replaced with T, E, * and N.
• When QRCODE type is selected, d1...d k (d1...dn) consists of 5 parts, with format as
follows:
1)
D: Link structure mode, input specific mark symbol"D". This mode is optional and the
following three parameters and separator should be assigned if this mode is
selected.
aa: The position of the specific symbol, input 2 decimal numbers.
bb: The total number of the symbols, input 2 decimal numbers.
cc: The even and odd data, input 2 hexadecimal numbers.
, and : are fixed separator symbol.
2)
3)
4)
5)
Note: n>=200
Character input mode<N, A, B, K>
N: Numbers (0~9)
A: Mixed by alphabet and numbers (0~9)(A~Z)(SP,$,%,*,+,-,.,/,:)
Bxxxx: 8 bit byte mode (0x00~0xFF)
78 GS1
Daabbcc,
E: Error correction grade, range: L, M, Q, H. The correction grade increases from
L to H.
M: Mask image reference, range: Default is automatic mask.
M: Data input mode, range: A or M, A means automatic mode (Recommended).
M means manual input mode. If A is selected, the character mode is not
necessary to be assigned; if M selected, the character mode must be assigned.
The default is A mode.
<Character mode><DATA1>,
< Character mode ><DATA2>,
< Character mode ><DATA3>,
............................
< Character mode ><DATAn>
BTP-R580II Programming Manual
1 ≤ n ≤255
- 46 -
Determined by the
parameters of GS1