Dle Dc4 N M T Generate Pulse At Real Time To Open Cash Drawer; Esc 2 Set Default Line Spacing - SNBC BTP-R580II Programming Manual

[Range] 1 ≤n ≤ 2
[Notes] The meaning of n is as follows:
n
1
2
• This command is enabled only when cutter error or mark location failure occurs.
• The printer starts processing data upon receiving this command in serial mode.
• This command can not be executed when the printer is busy in parallel mode.
• When the printer is disabled by ESC = (Select peripheral device), the command is
still valid.
• Do not insert the command into the command sequence of 2 or more bytes.
[Reference] DLE EOT

DLE DC4 n m t Generate pulse at real time to open cash drawer

[Function] Generate pulse at real time to open cash drawer.
[Format] ASCII
Hex
Decimal 16
[Range] n = 1
0 ≤ m≤ 1
1 ≤ t≤ 6
[Notes] m specifies the relevant pin:
• The high level time is [t×100 ms], and the low level time is [2×t×100 ms].
• This command is ignored when printer executes cash drawer open command (ESC p
or DEL DC4).
• The printer starts processing data upon receiving this command in serial mode.
• This command can not be executed when the printer is busy in parallel mode.
• If print data includes the same data as this command, then those data will be
performed as the command. User must consider this.
• When the printer is disabled by ESC = (Select peripheral device), the command is
still valid.
• Do not insert the command into the command sequence of 2 or more bytes.
[Relative] ESC p

ESC 2 Set default line spacing

[Function] Select default line spacing to 1/6 inch (about 4.23mm)
[Format] ASCII
Hex
Recover from an error and restart printing from the line where the
error occurred
Recover from an error and clear the data in receive and print
buffers
DLE DC4 n
10 14 n
20 n
m
0 Cash drawer kick-out connector pin 2
1 Drawer kick-out connector pin 5
ESC 2
1B 32
Request
m t
m t
m t
Connector pin
- 61 -
BTP-R580II Programming Manual