Fs & Select Chinese Mode - SNBC BTP-R580II Programming Manual

Decimal 28 33 n
[Range] 0 ≤n ≤ 255
[Notes] n specifies the print mode of Chinese:
Bit
0, 1
2
3
4-6
7
• When both double-width and double-height modes are set (including right and left
character spacing), quadruple-size characters are printed.
• The printer can underline all characters (including right and left character spacing),
but cannot underline the space set by HT command (horizontal tab) and 90°
clockwise-rotated characters.
• The thickness of the underline is specified by FS -, regardless of the character size.
• When characters in a line have different height, all the characters in the line are
aligned at the baseline.
• It is possible to emphasize characters using FS W or GS!. The setting of the last
received command is effective.
• It is possible to select or cancel the underline mode using FS -, and the setting of the
last received command is effective.
[Default] n = 0
[Relative] FS - , FS W,GS !
[Example] See ESC ！
FS & Select Chinese mode
[Function] Select Chinese mode.
[Format] ASCII
Hex
Decimal 28 38
[Notes] • When Chinese mode is selected, the printer checks whether the character is
Chinese internal code or not. If it is Chinese internal code, printer will firstly process
the first byte; then printer will check if the second byte is Chinese internal code or
not.
• Chinese mode is selected automatically when the power of printer is turned on;
[Relative] FS . , FS C
0/1 Hex Decimal
0 00 0
1 04 4
0 00 0 Cancel double-height mode
1 08 8
0 00 0
1 80 128
FS &
1C 26
Function
Undefined
Cancel double-width mode
Select double-width mode
Select double-height mode
Undefined
Cancel underline mode
Select underline mode
- 29 -
BTP-R580II Programming Manual