Paper Near End Adjustment; Paper Near End Position Adjustment; Remaining Paper Amount Adjustment Of Paper Near End Sensor - SNBC BTP-R990 User Manual

BTP-R990 User's Manual

4.8 Paper near end adjustment

4.8.1 Paper near end position adjustment

BTP-R990 supports printing in horizontal and vertical positions. Users can realize the detection of
remaining paper in horizontal and vertical by adjusting the position of paper near end sensor. The
default printer setting is horizontal printing and the paper near end sensor is at the bottom of the paper
cabinet.
To change the paper near end sensor position: First, press the plastic slip in position 1 along the
direction of the arrow. Then rotate thumb wheel in the direction shown in the figure. The paper near end
sensor will start to rotate. When the plastic slip reaches at position 2, the change of paper near end
sensor position from horizontal to vertical is complete. Reverse operation will change the paper near
end sensor position from vertical to horizontal.

4.8.2 Remaining paper amount adjustment of paper near end sensor

Remaining paper amount can be adjusted by adjusting the position of paper near end sensor. Paper
near end sensor has six levels, the dark part (real object on printer is raised) shows the current level,
and the red mark can be adjusted to a different position by moving the thumb wheel, through which the
remaining paper amount is changed.
- 10 -