Load/Replace A Paper Roll; Paper Near End Position Adjustment - SNBC BTP-R580 User Manual

4.6.2 Load/replace a paper roll

1) Press the latch of the top cover and open it.
2) Place a paper roll in the paper holder.
3) Close the printer top cover.
Caution:
If needed remove the paper guide. Choose the suitable paper guide position according to the
width of the paper roll and mount the paper guide. When inserting the paper roll pay attention
to the paper path direction.
Note: Without paper guide:
Paper guide in the slot A:
Paper guide in the slot B:
Ensure that the paper is rolled tightly onto the paper roll, otherwise a paper jam or other fault
could happen.
The paper roll should be placed straight in the paper holder and not slantingly. The paper roll
should be able to move freely.

4.7 Paper near end position adjustment

Through adjustment of the latch of the paper near end sensor to a corresponding level, different
82.5±0.5mm.
80±0.5mm
57.5±0.5mm
- 12 -
BTP-R580 User's Manual