Gs W Nl Nh Set Print Area Width - SNBC BTP-R580II Programming Manual

starting position of print area:
① When the print starting position is set to the upper left (Print direction from left to
② When the print starting position is set to the upper right (print direction from top to
• The command does not affect the previously specified values.
• The minimum motion unit is the compositive result of this command and other
commands.
• 1 inch=25.4mm.
[Default] x = 203, y =203, at this time, one motion unit is a printing dot. The horizontal distance
is about 1/8mm and the vertical distance is about 1/8mm.
[Relative] ESC SP, ESC $, ESC 3, ESC J, ESC W, ESC \, GS $, GS L, GS V, GS W, GS \

GS W nL nH Set print area width

[Function] Set print area width.
[Format] ASCII
Hex
Decimal 29
[Range] 0 ≤ nL ≤ 255
0 ≤ nH ≤ 255
[Notes] • Set print area width to [ ( nL + nH × 256) ×horizontal motion unit) ] inches.
• In standard mode, this command is enabled only when processed at the beginning of
the line.
• In page mode, this command is disabled.
• This command does not affect printing in page mode.
• If the [left margin + print area width] exceeds the printable area, the print area width is
[printable area width - left margin].
• The horizontal and vertical motion units are specified by GS P. Changing the
horizontal and vertical motion units does not affect the current left margin or print
area width.
• The horizontal motion unit is used for calculating the print area width.
[Default] nL = 76, nH = 2
right) or lower right (Print direction from right to left) of the print area by ESC T:
Commands using x: ESC SP, ESC $, ESC W, ESC \, FS S
Commands using y: ESC 3, ESC J, ESC W, GS $, GS \, GS V
bottom) or lower left (print direction from bottom to top) of the print area by ESC T:
Commands using x: ESC 3, ESC J, ESC W, GS $, GS \
Commands using y: ESC SP, ESC $, ESC W, ESC \,FS S, GS V
GS W nL nH
1D 57 nL nH
87 nL nH
BTP-R580II Programming Manual
- 14 -