Gs $ Nl Nh Set The Absolute Vertical Position In; Gs L Nl Nh Set Left Margin - SNBC BTP-R580II Programming Manual

GS $ nL nH Set the absolute vertical position in page mode
[Function] This command sets the absolute vertical position in page mode.
[Format] ASCII
Hex
Decimal 29
[Range] 0 ≤ nL ≤ 255, 0 ≤ nH ≤ 255
[Notes] • This command is enabled only in page mode.
• If the [(nL + nH × 256) × (vertical or horizontal motion unit)] exceeds the specified
print area, this command is ignored.
• The horizontal position does not move after executing this command.
• The positions of relative commands are specified by ESC T
• Depending on the print area direction and starting position specified by ESC T, this
command operates as following:
① When the starting position is set to the upper left or lower right, this command sets
② When the starting position is set to the upper right or lower left, this command sets
• The horizontal and vertical motion units are specified by GS P.
[Relative] ESC $, ESC T, ESC W, ESC \, GS P, GS \
[Example] Refer to ESC W.

GS L nL nH Set left margin

[Function] Set left margin to [ ( nL + nH × 256) × horizontal motion unit)] inches.
[Format] ASCII
Hex
Decimal 29 76 nL nH
[Range] 0 ≤ nL ≤ 255
0 ≤ nH ≤ 255
[Notes] • In standard mode, this command is enabled only when processed at the beginning of
the line.
• If this command is input in page mode, it is disabled. The printer will process the
command as normal character.
GS $ nL nH
1D 24 nL nH
36 nL nH
the absolute position in the direction which is parallel to the paper feed direction.
the absolute position in the direction which is perpendicular to the paper feed
direction.
GS L nL nH
1D 4C nL nH
BTP-R580II Programming Manual
- 12 -