Gs { W N Enter\Exit Watermark Mode - SNBC BTP-R580II Programming Manual

Hex
Decimal 29 123 119 02 n1 n2 n3 n4 n5
[Range] 0 ≤ n1 ≤ 1
0 ≤ n2 ≤ 2
n3 parameter selection can be found in the table below.
0 ≤ n4 ≤ 255
1 ≤ n5 ≤ 255
[Notes] • n1 indicates watermark print mode:
n1 = 0: print watermark bitmap when feeding paper
n1 = 1: print watermark bitmap when printing
• n2 indicates watermark align mode
n2 = 0: left justification
n2 = 1: centering
n2 = 2: right justification
• n3 indicates watermark enlargement mode selection, bit 0-3 selects height, bit 4-7
selects width, values are as below:
Hex
10
20
30
40
50
60
• n4 indicates watermark brightness adjustment, recommended value 0x20.
• n5 indicates the number of bitmap( defined by FS q command).
• This command is enabled only when used at the beginning of the line.
• This command is valid only in line mode, invalid in page mode.
• Before using this command, use FS q to define NV bitmap first.
[Example] 1D
Explanation
n1=0x01: Watermark bitmap is printed only when there is a printing task.
n2=0x00: watermark bitmap left justification.
n3=0x22: watermark bitmap is enlarged twice horizontally and vertically respectively.
n4=0x40: watermark brightness is 0x40.
n1=0x01: regard the NV bitmap whose number is 1 as watermark bitmap.

GS { w n Enter\exit watermark mode

[Function] Enter\exit watermark mode.
[Format] ASCII
Hex
Decimal 29 123 119 n
1D 7B 77 02 n1 n2 n3 n4 n5
Width
Horizontal
Decimal
enlargement
16 1 (normal)
2
32
(double-width)
48 3
64 4
80 5
96 6
7B 77 02 01 00 22 40 01
GS { w n
1D 7B 77 n
BTP-R580II Programming Manual
Height
Hex Decimal
01 1
02 2
03 3
04 4
05 5
06 6
- 56 -
Vertical
enlargemen
t
1 (normal)
2
(double-heig
ht)
3
4
5
6