Esc 3 N Set Line Spacing; Esc = N Select Printer - SNBC BTP-R580II Programming Manual

Decimal 27
[Notes] The line spacing can be set independently in standard mode and in page mode.
[Relative] ESC 3

ESC 3 n Set line spacing

[Function] Set line spacing.
[Format] ASCII
Hex
Decimal 27
[Range] 0 ≤ n ≤ 255
[Notes] • The line spacing can be set independently in standard mode and in page mode.
• The horizontal and vertical motion units are specified by GS P. Changing the
horizontal or vertical motion unit does not affect the current line spacing.
• In standard mode, the vertical motion unit is used.
• In page mode, the horizontal or vertical motion units are selected as follows,
depending on the print direction and print starting position:
① When the print starting position is set to the upper left or lower right of the print
② When the print starting position is set to the upper right or lower left of the print
• The maximum paper feed amount is 1016 mm (about 40 inches) . Even if a paper
feed amount of more than 1016 mm (40 inches) is set, the printer feeds the paper
only 1016 mm (40 inches).
[Default] The default line spacing is approximately 4.23mm (1/6 inch).
[Relative] ESC 2, GS P

ESC = n Select printer

[Function] Select printer and the selected printer can receive data sending from host computer.
[Format] ASCII
Hex
Decimal 27
[Range] 0≤ n ≤ 1
[Notes] The meaning of n is as follows:
Bit
0
1-7
• When the printer is disabled, it ignores all commands except for immediate
commands (DLE EOT, DLE ENQ, DLE DC4).
[Default] n = 1
50
ESC 3 n
1B 33 n
51 n
area by ESC T, the vertical motion unit is used;
area by ESC T, the horizontal motion unit is used;
ESC = n
1B 3D n
61 n
1/0 Hex
0 00
1 01
Decimal
0 Printer disabled
1 Printer enabled
Undefined
- 62 -
BTP-R580II Programming Manual
Function