Symbolic Status Event Register Evaluation - Rohde & Schwarz GSM400-MS Operating Manual

Common: Symbolic Status Event Register Evaluation
CONFigure:IQIF:RXPath <Path>
<Path> Description of parameters
BYP Bypass
BYIQ Bypass w. I/Q-IF OUT
XOIO I/Q IN/OUT
IOIO IF IN_I/Q IN/OUT
IOXO IF IN/OUT
Description of command
This command selects the RX signal path, leaving the TX path (see command CONFigure:IQIF:TXPath
below) unchanged but adapting the I/Q-IF test scenario to the new RX/TX path combination: If the combination
corresponds to a predefined scenario, then CONFigure:IQIF:RXTXcombined is set to the predefined
scenario; otherwise it is set to UDEF.
CONFigure:IQIF:TXPath <Path>
<Path> Description of parameters
BYP Bypass
BYIQ Bypass w. I/Q-IF OUT
XOIO I/Q IN/OUT
IOIO IF IN_I/Q IN/OUT
IOXO IF IN/OUT
Description of command
This command selects the TX signal path, leaving the RX path (see command CONFigure:IQIF:RXPath
above) unchanged but adapting the I/Q-IF test scenario to the new RX/TX path combination: If the combination
corresponds to a predefined scenario, then CONFigure:IQIF:RXTXcombined is set to the predefined
scenario; otherwise it is set to UDEF.
IQIF:DEFault <Enable>
<Enable> Description of parameters
ON | The parameters are set to their default values
OFF Some or all parameters differ from the default values
Description of command
If used as a setting command with the parameter ON this command sets all parameters of the subsystem to their
default values (the setting OFF causes an error message).
If used as a query the command returns whether all parameters are set to their default values (ON) or not (OFF).

Symbolic Status Event Register Evaluation

The following commands are used to retrieve the events reported in function groups
GSM400/850/900/1800/1900-MS Non Signalling and Signalling; see section Symbolic Status Event
Register Evaluation in Chapter 5 of the CMU operating manual.
1115.6088.12
Def. value
BYP
Def. value
BYP
Def. value
ON
6.34
CMU-K20/21/22/23/24
RX Path
Def. unit FW vers.
– V3.10
TX Path
Def. unit FW vers.
– V3.10
Default Settings
Def. unit FW vers.
– V3.10
E-12