Table of Contents
Advertisement
Programmable DC Electronic Load 63600 Series Operation & Programming Manual
4.4.4 Setting CV Values
When operate in CV mode, the VFD displays CV mode.
There are three voltage ranges for CV operation: high voltage range, middle voltage range,
and low voltage range. The current is always in high range. ALL voltage levels are
programmed in V. The following examples show how to set the CV values of Load module
for model 63630-80-60.
1.
Select Range
Select proper range, by pressing
RANGE
the
key is lights up. High range is used when higher voltage level is required,
and LOW range is used when better resolution is required.
Select LOW range, by pressing
lights up.
The sequence of range selection after pressing
High range Middle range Low range goes back to High range
2.
Select state A/B for single channel module
For single channel module, press the
LED "A" or LED "B" above the key
A/B
key to select state A, then the LED "A" above the key
3.
Set Voltage Level
There are 15,000 discrete steps from 0 to full scale in each range. Press the
key to enter into the editing mode. Turn the Rotary knob to change the display value to
5 V, then press
The user may use
data, then turn the rotary knob to change the value of that digit.
If the user does not use
value changes according to the rotary knob turning speed.
4.
Set the second Voltage Level for single channel module
A/B
Press the
4-12
0 . 0 0 0 0
0 . 0 0 0 0
0 . 0 0 0 0
CV
RANGE
RANGE
A/B
ENTER
key to confirm.
5.0000
or
key to change the cursor position to different digit of
or
key to select State B then the LED "B" above the key lights up.
mV
mA
mW
key, until the LED of the desired range above
key, until the LED "L" above the
RANGE
key is as follows:
A/B
key to select state A or state B, then the
lights up. Select state A, by pressing the
V
key to display the cursor, then resolution of the
RANGE
key
A/B
lights up.
EDIT
Advertisement
Table of Contents
