Setting Operation Mode Of Dynamic Load; Setting The Operation Mode To Cc Mode - Chroma 63610-80-20 Operation & Programming Manual

Programmable dc electronic load
Table of Contents

Advertisement

4.
Set the Level of the equivalent series resistance Rs
The setting range is from 30mΩ to 20Ω. There are 15,000 discrete steps in the range.
EDIT
Press the
the display value to 0.15Ω, then press
5.
Review and update the values of the setting parameters
Review the values of the setting parameters by pressing
set new value in their setting pages.
After completion of the data edit,
DATA
key, new data will not be written into the internal memory, the previous value for
the parameter is kept.
6.
Quit from editing mode
EDIT
Press
to quit from editing mode. Then, the VFD display will go back to the
voltage, current, and peak plus/minus voltage display mode.

4.5 Setting Operation Mode of Dynamic Load

4.5.1 Setting the Operation Mode to CC Mode

Dynamic load is only operation in CC mode. Press the
displays CC mode.
The sequence of mode selection after pressing
CC  CR  CV  CP  CZ goes back to CC
key to enter into the editing mode. Turn the Rotary knob to change
Rs :
00.15
ENTER
0 . 0000
0 . 0000
0 . 0000
CC
ENTER
key to confirm.
Ω
DATA
key must be pressed. Otherwise, pressing the
MODE
key repeatedly until the VFD
mV
mA
mW
MODE
key is as follows:
Local Operation
key. Update them by
4-17

Advertisement

Table of Contents
loading

Table of Contents