Chroma 63610-80-20 Operation & Programming Manual page 164

Programmable DC Electronic Load 63600 Series Operation & Programming Manual
ADVance:TIMing:ENDVoltage
Type:
Description:
Setting Syntax:
Setting Parameters:Refer to respective specification for valid value range.
Setting Example:
Query Syntax:
Return Parameters:<NR2>, [Unit = Volt]
Query Example:
ADVance:TIMing:FALL
Type:
Description:
Setting Syntax:
Setting Parameters:Refer to respective specification for valid value range.
Setting Example:
Query Syntax:
Return Parameters:<NR2>, [Unit = A/uS]
Query Example:
ADVance:TIMing:MODE
Type:
Description:
Setting Syntax:
Setting Parameters:<CRD | NR1>, CC(0), CR(1), CP(2)
Setting Example:
Query Syntax:
Return Parameters:<CRD>, CC, CR, CP
Query Example:
ADVance:TIMing:RISE
Type:
Description:
Setting Syntax:
Setting Parameters:Refer to respective specification for valid value range.
Setting Example:
Query Syntax:
Return Parameters:<NR2>, [Unit = A/uS]
5-32
Channel-Specific
Set end voltage when trigger mode set to HOLD_UP for Timing
mode.
ADVance:TIMing:ENDVoltage<space><NRf+>[suffix]
ADV:TIM:ENDV 0.5
ADV:TIM:ENDV 500mV
ADV:TIM:ENDV MAX
ADV:TIM:ENDV MIN
ADVance:TIMing:ENDVoltage?[<space><MAX | MIN>]
ADV:TIM:ENDV?
ADV:TIM:ENDV? MAX
ADV:TIM:ENDV? MIN
Channel-Specific
Set falling slew rate of current in Timing mode.
ADVance:TIMing:FALL<space><NRf+>[suffix]
ADV:TIM:FALL 0.1
ADV:TIM:FALL 100mA/μs
ADV:TIM:FALL MAX
ADV:TIM:FALL MIN
ADVance:TIMing:FALL?[<space><MAX | MIN>]
ADV:TIM:FALL?
ADV:TIM:FALL? MAX
ADV:TIM:FALL? MIN
Channel-Specific
Set run mode in Timing mode.
ADVance:TIMing:MODE<space><CRD | NR1>
ADV:TIM:MODE CR
ADV:TIM:MODE 1
ADVance:TIMing:MODE?
ADV:TIM:MODE?
Channel-Specific
Set rising slew rate of current in Timing mode.
ADVance:TIMing:RISE<space><NRf+>[suffix]
ADV:TIM:RISE 0.1
ADV:TIM:RISE 100mA/μs
ADV:TIM:RISE MAX
ADV:TIM:RISE MIN
ADVance:TIMing:RISE?[<space><MAX | MIN>]
Set end voltage = 0.5V
Set end voltage = 0.5V
Set end voltage = maximum value.
Set end voltage = minimum value.
Set slew rate = 0.1A/μs
Set slew rate = 0.1A/μs
Set slew rate = maximum value.
Set slew rate = minimum value.
Set run mode = CR mode
Set run mode = CR mode
[Unit = None]
Set slew rate = 0.1A/μs
Set slew rate = 0.1A/μs
Set slew rate = maximum value.
Set slew rate = minimum value.