Chroma 63610-80-20 Operation & Programming Manual page 166

Programmable DC Electronic Load 63600 Series Operation & Programming Manual
Query Syntax:
Return Parameters:<NR2>, [Unit = Volt]
Query Example:
ADVance:TIMing:VALue
Type:
Description:
Setting Syntax:
Setting Parameters:Refer to respective specification for valid value range.
Setting Example:
When ADV:TIM:MODE set to CC mode, then
When ADV:TIM:MODE set to CR mode, then
When ADV:TIM:MODE set to CP mode, then
Query Syntax:
Return Parameters:<NR2>, [Unit = Ampere | Ohm | Watt]
Query Example:
[ADVance:]USER:WAVeform:NSELect
Type:
Description:
Setting Syntax:
Setting Parameters:<NRf+>, 1 ~ 10, Resolution = 1, Unit = None
Setting Example:
Query Syntax:
Return Parameters:<NR1>, [Unit = None]
Query Example:
5-34
ADV:TIM:TRIG:VSTA 500mV
ADV:TIM:TRIG:VSTA MAX
ADV:TIM:TRIG:VSTA MIN
ADVance:TIMing:TRIG:VSTArt?[<space><MAX | MIN>]
ADV:TIM:TRIG:VSTA?
ADV:TIM:TRIG:VSTA? MAX
ADV:TIM:TRIG:VSTA? MIN
Channel-Specific
Set load value according to the run mode in Timing mode. Notice
every time when the run mode of timing is changed this setting will
be reset to zero.
ADVance:TIMing:VALue<space><NRf+>[suffix]
ADV:TIM:VAL 0.5
ADV:TIM:VAL 500mA
ADV:TIM:VAL MAX
ADV:TIM:VAL MIN
ADV:TIM:VAL 0.5
ADV:TIM:VAL 500mΩ
ADV:TIM:VAL MAX
ADV:TIM:VAL MIN
ADV:TIM:VAL 0.5
ADV:TIM:VAL 500mW Set power = 0.5W.
ADV:TIM:VAL MAX
ADV:TIM:VAL MIN
ADVance:TIMing:VALue?[<space><MAX | MIN>]
ADV:TIM:VAL?
ADV:TIM:VAL? MAX
ADV:TIM:VAL? MIN
Channel-Specific
Set the active waveform to run for user-define waveform function.
[ADVance:]USER:WAVeform:NSELect<space><NRf+>
USER:WAV:NSEL 5
USER:WAV:NSEL MAX
ADV:USER:WAV:NSEL MIN
[ADVance:]USER:WAVeform:NSELect?[<space><MAX | MIN>]
USER:WAV:NSEL?
Set start voltage = 0.5V
Set start voltage = maximum
value.
Set start voltage = minimum
value.
Set current = 0.5A
Set current = 0.5A
Set current = maximum value.
Set current = minimum value.
Set resistance = 0.5Ω.
Set resistance = 0.5Ω.
Set resistance = maximum value.
Set resistance = minimum value.
Set power = 0.5W.
Set power = maximum value.
Set power = minimum value.
Set active waveform = 5
Set active waveform = maximum
value.
Set active waveform = minimum
value.